Arctic Cat M8 Install Pictures
Donor Sled, 2009 Arctic Cat M8, (Thanks Cale). Cale wanted a hidden installation under the hood.
Mounting location, we used 2 x 6/32 nuts and bolts with 2 small holes drilled through the aluminum plate. We used a terminal strip to extend wires.
The Brown and Green wires (Normally Open Contacts) from our relay were paralleled on to the ignition switch. (red wire was used to extend the brown in this case) The "crimp on" connectors worked well.
We found D.C. power on the lower connection to the backup beeper. We used a piggy back blade connector and a Red extension wire to our control unit. The beeper was located in the right foot rest area.
Make sure the power wire doesn't chafe on the sharp aluminum parts, put split loom covering or shrink tubing over it.
Prepare the antenna with zip ties to mount on the handle bar near the throttle control. (Yamaha shown, picture 2)
Completed installation, took about 1 hour.